volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing cylinder head > < Removing

Golf Mk4

Installing
Installing
Installation is carried out in the reverse sequence of removal.
  Note
t  Replace cylinder head cover if damaged or leaking.
t  Bolt intake manifold upper part to intake manifold lower part, then tighten both bolts of intake manifold support.
t  Ensure that fuel hoses are tight.
–  If necessary fill with coolant → Chapter.
–  Adjusting throttle cable → Chapter.
–  Read fault memory: → Motronic injection and ignition system (5-cyl. engine); Rep. Gr.01
Specified torques
   
Threaded connection Specified torque
Cylinder head cover to cylinder head10 Nm
Intake manifold upper part to intake manifold lower part 25 Nm
Intake manifold upper part to left and right of support25 Nm
Support for intake manifold upper part to cylinder head25 Nm

   

Removing and installing cylinder head > < Removing