Golf Mk4
| Assembly overview |
| 1 - | 100 Nm + 1/2 turn (180°) further |
| q | Renew. |
| q | To loosen and tighten, use counterhold -T10069- → Chapter |
| q | Tighten using torque wrench -V.A.G 1601-. |
| 2 - | Vibration damper |
| q | Removing and installing poly V-belt → Chapter. |
| 3 - | 10 Nm |
| 4 - | Seal |
| q | Can only be renewed separately on metal sealing flange → Chapter |
| 5 - | Sealing flange |
| q | In plastic finish with seal |
| q | Renew. → Chapter. |
| q | Coat sealing surfaces with sealant D 176 501 |
| 6 - | Cylinder block |
| q | Removing and installing crankshaft → Chapter. |
| q | Dismantling and assembling pistons and conrods → Chapter. |
| 7 - | Sealing flange |
| q | Coat sealing surfaces with sealant D 176 501 |
| 8 - | Seal |
| q | Remove using extractor hook -T20143/2-. |
| q | PTFE oil seal: |
| q | Identification: Without inner coil spring. |
| q | Do not additionally oil or grease the oil seal sealing lip. |
| q | Before installing, remove oil residue from crankshaft journal using a clean cloth. |
| q | Removing and installing → Chapter |
| 9 - | Dual-mass flywheel |
| 10 - | 60 Nm + 1/4 turn (90°) further |
| q | Renew. |
| q | To loosen or tighten, use counterhold -T10044- (with 5 mm spacers) or counterhold -T10069-. |
| 11 - | 25 Nm |
