volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Dismantling and assembling triple roller joint > < II - Repairing front drive shaft with constant velocity joint VL 3700
III - Repairing front drive shaft with triple roller joint AAR 2000
   
III - Repairing front drive shaft with triple roller joint AAR 2000
Special tools and workshop equipment required
t  Thrust plate -VW 401-
t  Thrust plate -VW 402-
t  Press tool -VW 408 A-
t  Press tool -VW 411-
t  Tube -VW 416 B-
t  Thrust plate -VW 447 H-

   
t  Pliers -V.A.G 1275-
t  Torque wrench -V.A.G 1331-
t  Torque wrench -V.A.G 1332-
t  Pliers -V.A.G 1682-
t  Assembly tool -T10065-

Grease quantities and types
Joints are filled with high-temperature grease. → Electronic parts catalogue (ETKA)
   
 Greaseof which in:
Outer jointTotal quantityJointBoot
Ø mm[g][g][g]
901005050
Inner joint   
Ø mm   
1001105555
1081105555

Regrease joint if required when renewing boot.
   
1 - Self-locking 12-point nut
q   Tightening → Chapter.
q   Remove any corrosion on thread of outer joint before fitting nut.
2 - Outer constant velocity joint
q   Renew only complete.
q   Removing → Fig..
q   Installing: drive onto shaft with plastic hammer until compressed retaining ring seats.
q   Checking → Chapter.
q   Greasing → .
3 - Retaining ring
q   Insert in groove in shaft.
4 - Thrust washer
q   Installation position → Fig..
5 - Dished spring
q   Outer Ø (concave side) contacts thrust washer.
6 - Clamp
q   Renew each time after removing.
q   Tighten with pliers -V.A.G 1682- → Fig..
7 - Constant velocity joint boot
q   Check for splits and chafing.
8 - Clamp
q   Renew each time after removing.
q   Tightening → Fig..
9 - Drive shaft
10 - Triple roller joint boot
q   Check for splits and chafing.
11 - Clamp
For triple roller joint
q   Renew each time after removing.
q   Tightening → Anchor.
12 - Multi-point socket head bolt
Torque settings: → 
13 - Locking plate
Fitted only on joints with 108 mm Ø.
14 - Joint body
15 - Triple roller star with rollers
The chamfer -arrow- points towards drive shaft splines.
16 - Retaining ring
q   Always renew.
17 - O-ring
q   Always renew.
18 - Cover
q   Always renew.

   

Dismantling and assembling triple roller joint > < II - Repairing front drive shaft with constant velocity joint VL 3700