volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Renewing seal between gearbox and bevel box > < Removing

Golf Mk5

Installing
Installing
–  Lightly oil outer circumference of new oil seal.
   
–  Drive in new seal to stop, being careful not to cant seal.
  N39-0764
–  Fill space between sealing lip and dust lip -arrow- with sealing grease -G 052 128 A1-.
–  Carefully drive in right flange shaft; turn flange shaft so that bearing is not damaged.
–  Secure flange shaft using countersunk bolt and tighten to specified torque → Item.
Carry out further installation in the reverse sequence noting the following points:
–  If the particulate filter support was removed on vehicles with particulate filter, this must now be reinstalled. → Rep. gr.26
  N32-0001
–  Install right drive shaft → Running gear, axles, steering; Rep. gr.40.
–  Install drive shaft heat shield, if present -arrows- → Running gear, axles, steering; Rep. gr.40.
Drive shaft heat shield is secured with 3 nuts, or with 2 nuts for some engines. → Running gear, axles, steering; Rep. gr.40
–  Check gear oil in bevel box → Chapter.
–  Check gear oil in gearbox → Chapter.
–  Install noise insulation → General body repairs, exterior; Rep. gr.50.
–  Install wheel → Running gear, axles, steering; Repair group 44; Wheel bolt torque setting.
  A10-10260

Renewing seal between gearbox and bevel box > < Removing