Checking position of adjusting mechanism with new pressure plates only |
l
| Both edges -A- of the adjuster ring must be located between the two notches -arrows B-. |
l
| If the adjuster ring takes up a different position in new pressure plates, the pressure plate and clutch plate are not allowed to be installed. |
l
| The adjuster ring may take up a position outside the notches in used clutches. |
Note t
| Renew clutch plates and pressure plates with damaged or loose rivet connections. |
t
| Renew pressure plate and clutch plate together only. |
t
| Clean input shaft splines and, on used clutch plates, hub splines; remove corrosion and apply only a very thin coat of grease -G 000 100- to splines. Then move clutch plate to and fro on input shaft until hub moves freely on shaft. Remove excessive grease. |
t
| Pressure plates are protected against corrosion and greased. Clean contact surface only. Otherwise, the service life of the clutch will be considerably reduced. |
t
| Pressure plate contact surface and clutch plate lining must make full contact with flywheel. Only then insert securing bolts. |
|
|
|