volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Checking function of Haldex coupling "Haldex generation II" > < Renewing bonded rubber bush on rear final drive - Golf

Golf Mk5

Renewing oil seals for flange shafts (rear final drive 0AV)
Renewing oil seals for flange shafts (rear final drive 0AV)
Removing flange shaft oil seal
Perform the following steps:
–  Remove drive shaft → Running gear, axles, steering; Rep. gr.42
–  Place drip tray under rear final drive.
   
Removing left flange shaft
–  Screw one M8 nut -arrow- onto thread of puller -T10037- until it is flush with start of thread.
–  Pull out flange shaft with puller -T10037-.
  A39-10055
Removing right flange shaft
–  Screw one M8 nut -arrow- onto thread of puller -T10037- until it is flush with start of thread.
–  Pull out flange shaft with puller -T10037-.
Continuation for both sides
  A39-10054
–  Lever out flange shaft oil seal using oil seal extractor -VW 681-.
Installing flange shaft oil seal
  A39-10056
–  Lightly oil new seal around outside circumference and drive in to stop with thrust piece -T10049-, taking care not to cant seal.
–  Half-fill space between sealing lip and dust lip with sealing grease -G 052 128 A1-.
  A39-10057
–  Clamp flange shaft in vice with protective jaw covers.
–  Use new retaining ring -A- to press old retaining ring out of groove in flange shaft.
–  Drive in flange shaft using plastic mallet and, if necessary, a drift.
–  Install drive shaft → Running gear, axles, steering; Rep. gr.42.
–  Checking gear oil level in rear final drive → Chapter.
  V34-2005

Checking function of Haldex coupling "Haldex generation II" > < Renewing bonded rubber bush on rear final drive - Golf