Golf Mk5
Assembly overview - silencer with mountings (vehicles with front wheel drive) |
1 - | 25 Nm |
q | Renew. |
2 - | Retaining ring |
q | Renew if damaged. |
3 - | Separating point |
q | Marked by indentation on exhaust pipe |
q | During production, front and rear silencers are installed as a single component. For repairs, front and rear silencers are supplied separately. |
q | The connection is made with a clamp. |
q | Separating exhaust end pipe → Chapter |
q | Installation position of rear clamp (repair double clamp) → Fig.. |
q | Evenly tighten threaded connections of clamping sleeve (repair double clamp) |
q | Specified torques for clamp (repair double clamp): M8 = 25 Nm, M10 = 40 Nm |
q | Before tightening, align cold exhaust system free of tension → Chapter |
4 - | Rear silencer |
5 - | Mounting |
q | Renew if damaged. |
6 - | 25 Nm |
7 - | Tunnel bridge |
8 - | Front silencer |
9 - | Mounting |
q | Renew if damaged. |
|