–
| Remove oil pressure switch -F1- using hinged lever, 24 mm -T40175- and screw into oil pressure tester -V.A.G 1342-. |
–
| Screw tester into cylinder head in place of oil pressure switch. |
–
| Connect brown wire of tester to earth (-). |
–
| Connect voltage tester -V.A.G 1527B- to battery positive (+) and oil pressure switch using cables from auxiliary measuring set -V.A.G 1594C-. |
–
| If LED lights up, renew oil pressure switch -F1-. |
If LED does not light up: |
–
| Start engine and increase speed slowly. At 0.3…0.7 bar the LED must light up, otherwise renew oil pressure switch. |
–
| Increase engine speed further. At 2,000 rpm and an oil temperature of 80°C the oil pressure should be at least 2.0 bar. |
At higher engine speeds, the oil pressure must not exceed 7.0 bar. |
|
|
|