volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing Lambda probe after catalytic converter G130 > < Aligning exhaust system stress free

Golf Mk5

Removing and installing Lambda probeG39
Removing and installing Lambda probe -G39-
Removing
Special tools and workshop equipment required
   
t  Lambda probe ring spanner set -3337-
  W00-0206
–  Take off engine cover panel -arrows-.
  A10-1564
–  Remove electrical connector -arrow- for Lambda probe -G39- from bracket and disconnect.
  A24-0731
–  Loosen wiring clip -1-.
–  Unscrew Lambda probe -arrow- using tool from Lambda probe open ring spanner set -3337-.
  Note
Illustration shows engine removed.
Installing
When installing, note the following:
  Note
t  When replacing Lambda probe, erase learnt values in engine control unit → vehicle diagnosis tester “Guided fault finding”..
t  New Lambda probes are coated with an assembly paste. The paste must not get into the slots on the probe body.
t  If reusing Lambda probe, lubricate threads of with high temperature paste -G 052 112 A3-. Paste may not come into contact with slots on probe body. High-temperature paste → Electronic parts catalogue (ETKA)
t  When installing, the Lambda probe cable must always be reattached at the same points to prevent it from coming into contact with the exhaust pipe.
t  Specified torque 55 Nm.
  A24-0741

Removing and installing Lambda probe after catalytic converter G130 > < Aligning exhaust system stress free