volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Checking oil pressure and oil pressure switch > < Assembly overview - oil filter, engine oil cooler and oil pressure switchF1

Golf Mk5

Removing and installing engine oil cooler
Removing and installing engine oil cooler
Special tools and workshop equipment required
   
t  Drip tray for workshop hoist -VAS 6208-
Removing
Proceed as follows:
  WARNING
When the engine is warm, the cooling system is under pressure.
Hot steam/hot coolant can escape - risk of scalding.
Cover filler cap on expansion tank with a cloth and open carefully to dissipate pressure.
–  Drain coolant → Chapter.
–  Remove bracket for ancillaries → Chapter.
  W00-10228
–  Unscrew bolts -4 and 5- and remove engine oil cooler -3- together with seal -2-.
Installing
Installation is carried out in the reverse order. When installing, note the following:
l  Specified torques → Chapter.
  Note
t  Renew gaskets and seals.
t  Secure all hose connections with the correct type of hose clips (same as original equipment) → ETKA (electronic parts catalogue).
  A17-10228
–  Install engine oil cooler -3- with new seal -2-.
  A17-10228

Checking oil pressure and oil pressure switch > < Assembly overview - oil filter, engine oil cooler and oil pressure switchF1