Volkswagen Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Test data, spark plugs >
< Removing and installing knock sensor 1G61
Golf Mk5
Power unit
4-cylinder injection engine (1.8 and 2.0 l engine, chain drive)
Ignition system, glow plug system / Repairing ignition system
Removing and installing engine speed senderG28
Removing and installing engine speed senderG28
Removing and installing engine speed sender -G28-
Removing
–
Remove engine cover.
–
Open hose clip
-2-
of air pipe.
–
Disconnect electrical connector
-arrow-
.
–
Remove noise insulation
→ General body repairs, exterior; Rep. gr.50
.
–
Undo and remove bolts
-1 and 4-
and pull air hose downwards off throttle valve module -J338-.
–
Pull air hose
-1-
off charge air cooler and take air pipe out downwards.
–
Detach electrical connector
-1-
at engine speed sender -G28-.
–
Undo and remove bolt securing engine speed sender -G28-.
Installing
Installation is carried out in the reverse order; note the following:
l
Specified torque
→ Item
.
Power unit
4-cylinder injection engine (1.8 and 2.0 l engine, chain drive)
Ignition system, glow plug system / Repairing ignition system
Removing and installing engine speed senderG28
Test data, spark plugs >
< Removing and installing knock sensor 1G61