Golf Mk5
Part 1 |
1 - | 15 Nm |
2 - | Oil dipstick |
q | Markings → Fig.. |
q | The oil level must not be above the max. mark! |
3 - | Dipstick guide |
4 - | Guide tube |
5 - | Intermediate plate |
6 - | Oil pump with balancer shaft gear assembly |
q | With 12 bar pressure relief valve. |
q | Removing and installing → Chapter. |
7 - | 15 Nm + 1/4 turn (90°) further |
q | Renew. |
q | Note different bolt lengths → Fig.. |
8 - | 15 Nm |
9 - | 8 Nm |
q | To secure charge air pipe. |
10 - | Oil sump |
q | Clean sealing surface before fitting. |
q | Removing and installing → Chapter. |
11 - | 15 Nm |
12 - | Oil drain plug |
q | 30 Nm |
q | With attached seal. |
q | Renew. |
13 - | Chain sprocket |
14 - | 10 Nm |
q | Not for engine code BPY |
15 - | Protective cap |
q | Not for engine code BPY |
16 - | Oil level and oil temperature sender -G266- |
q | Not for engine code BPY |
17 - | Seal |
q | Not for engine code BPY |
q | Renew. |
q | Lubricate before installing. |
18 - | 20 Nm + 1/4 turn (90°) further |
q | Renew. |
19 - | Chain guard |
20 - | Chain |
21 - | Sealing flange |
q | Must seat on dowel sleeves. |
q | Removing and installing → Chapter. |
q | Remove sump in order to remove and install → Chapter. |
q | Renewing crankshaft oil seal - belt pulley end → Chapter. |