volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Cleaning throttle valve moduleJ338 > < Removing and installing fuel rail

Golf Mk5

Removing and installing throttle valve moduleJ338
Removing and installing throttle valve module -J338-
Removing:
–  Remove engine cover/air filter → Chapter.
Golf:
   
–  Remove pipe -A- and hose -B--arrows-.
All vehicles:
  N24-10134
–  Loosen hose clip -1-.
–  Remove bolt -2-.
–  Remove noise insulation → General body repairs, exterior; Rep. gr.50
–  Disconnect electrical connector -3-.
–  Remove bolt -4- pull air pipe off charge air cooler and take downwards.
–  Remove four bolts of throttle valve module -J338- and remove throttle valve module -J338-.
Installing:
Installation is carried out in the reverse order. When installing, note the following:
–  If a new throttle valve module -J338- was installed, adapt the engine control unit to throttle valve module -J338- → Vehicle diagnostic tester„guided functions“.
  M24-0566

Cleaning throttle valve moduleJ338 > < Removing and installing fuel rail