volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Installing > < Removing and installing sump

Golf Mk5

Removing
Removing
–  Remove centre and right-hand insulation tray: → Rep. Gr.50.
–  Drain engine oil.
  Note
Observe environmental regulations for disposal.
–  Pull 3-pin connector off oil level and oil temperature sender -G266-.
–  Loosen and tighten sump bolts using 10 mm jointed wrench -3185-. Loosen or tighten flywheel-end bolts only with allen key, long reach -T10058-.
–  Remove sump. If necessary, loosen sump using light blows with rubber-headed hammer.
–  Remove sealant residue on cylinder block with a flat scraper.
   
–  Remove sealant residue on sump using a rotating brush, e.g. a hand drill with a plastic brush attachment (wear protective glasses).
–  Clean sealing surfaces. They must be free of oil and grease.
  N17-0012

Installing > < Removing and installing sump