| When working on the fuel supply and injection system, pay careful attention to the following “5 rules”: |
| t
| Thoroughly clean all unions and the adjacent areas before disconnecting. |
| t
| Place parts that have been removed on a clean surface and cover them over. Do not use fluffy cloths! |
| t
| Carefully cover or seal open components if repairs cannot be carried out immediately. |
| t
| Only install clean components: replacement parts should only be unpacked immediately prior to installation. Do not use parts that have been stored loose (e.g. in tool boxes etc.). |
| t
| When the system is open: Do not work with compressed air if this can be avoided. Do not move vehicle unless absolutely necessary. |
|
|
|
