Volkswagen Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Removing and installing ignition key withdrawal lock solenoidN376 >
< Removing and installing lock cylinder
Golf Mk5
Vehicle electrics
Electrical system
Lights, lamps, switches outside
Ignition/starter switch and lock cylinder
Removing and installing ignition/starter switch
Removing and installing ignition/starter switch
Removing and installing ignition/starter switch
Caution
When batteries are disconnected and reconnected, the procedure described in the workshop manual must be strictly observed
→ Chapter
.
Removing:
–
Disconnect battery
→ Chapter
.
–
Remove driver airbag
→ General body repairs, interior; Rep. gr.69
.
–
Remove steering wheel
→ Running gear; Rep. gr.48
.
–
Remove steering column trim
→ General body repairs, interior; Rep. gr.68
.
–
Pull connector
-2-
off ignition/starter switch
-1-
.
–
Release ignition/starter switch using small screwdriver
-arrows-
.
–
Pull ignition/starter switch
-1-
out of steering lock housing.
Installing:
–
Insert ignition/starter switch in steering lock housing until it can be heard to engage.
–
Insert ignition key in lock cylinder and turn to position „Drive“.
Note
The key must be in the „Drive“ position.
Positions for key in lock cylinder:
1 -
Position „Stop“
2 -
Position „Drive“
3 -
Position „Start“
–
Install all parts in reverse order of removal.
Vehicle electrics
Electrical system
Lights, lamps, switches outside
Ignition/starter switch and lock cylinder
Removing and installing ignition/starter switch
Removing and installing ignition key withdrawal lock solenoidN376 >
< Removing and installing lock cylinder