volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Removing and installing spray jet pop-up cylinders > < Assembly overview - headlight washer system
Removing and installing headlight washer system pumpV11
Removing and installing headlight washer system pump -V11-
The headlight washer system pump -V11- is mounted on the washer fluid reservoir in the right-hand wheel housing.
Removing:
–  Switch off ignition and all electrical consumers and remove ignition key.
–  Remove front bumper cover → General body repairs, exterior; Rep. gr.63.
   
–  Pull headlight washer pump -V11--9- upwards out of reservoir.
–  Disconnect connector -10-.
–  To remove the connecting pipe -8-, pull out securing clip and pull connecting pipe -8- off headlight washer system pump -V11-.
Installing:
Install in the reverse order of removal. When doing this, note the following:
–  Tighten all threaded connections to specified torques → Chapter.
–  On completion of installation work, bleed headlight washer system → Chapter.
  N92-10095

Removing and installing spray jet pop-up cylinders > < Assembly overview - headlight washer system