Golf Mk6
| Dimensions for securing screws |
Note| t | The stone-chip protection trim bolts are corrosion-resistant. No further secondary treatment is required. |
| t | If a bolt is overtightened it is essential to replace it with a „black“ oversize bolt. |
| l | There are no pre-drilled holes for the securing screws. |
| – | Measure holes according to table below. |
| – | Mark holes for securing screws with centre punch. |
| – | Drill out holes with a 1.5 mm drill bit. |
Note| t | Dimension -a- is measured including wheel housing liner -1-. The other dimensions -b to i- are always measured from the centres of the holes. |
| t | Dimension -k- can only be measured in rear area on 4-door vehicles. |
| t | For 2-door vehicles, determine dimension -k- in height to the front holes. |
| Table - Dimensions |
| Dimension -a- | = 855 mm |
| Dimension -b- | = 822 mm |
| Dimension -c- | = 617 mm |
| Dimension -d- | = 411 mm |
| Dimension -e- | = 205 mm |
| Dimension -f- | = 822 mm |
| Dimension -g- | = 617 mm |
| Dimension -h- | = 411 mm |
| Dimension -i- | = 205 mm |
| Dimension -k- | = 35 mm |
