Golf Mk6
| Assembly overview - door hinges |
Note| t | The right side is shown. The left side is similar. |
| t | The hinge bolts must always be renewed if loosened. |
| t | Hinges are one piece. |
| t | If a hinge is replaced, it must be greased. |
| 1 - | Door |
| q | Removing and installing → Chapter |
| q | Adjusting → Chapter |
| 2 - | Guide bolt |
| q | Specified torque: 10 Nm |
| 3 - | Door hinge with arrester |
| q | Greasing when hinge is replaced → Chapter |
| 4 - | Multi-point socket head bolt |
| q | Specified torque: 38 Nm |
| q | Always renew bolts after loosening. |
| 5 - | Cover |
| 6 - | Multi-point socket head bolt |
| q | Installed from inside vehicle. |
| q | Remove lower B-pillar trim → General body repairs, interior; Rep. gr.70. |
| q | Specified torque: 50 Nm |
| q | Always renew bolts after loosening. |
| 7 - | Multi-point socket head bolt |
| q | Specified torque: 38 Nm |
| q | Always renew bolts after loosening. |
| 8 - | Multi-point socket head bolt |
| q | Specified torque: 50 Nm |
| q | Always renew bolts after loosening. |
| 9 - | Bottom spacer plate |
| 10 - | Guide bolt |
| q | Specified torque: 10 Nm |
| 11 - | Adjuster ring |
| q | Restricts the adjustment range for the eccentric pin. |
| 12 - | Bolt |
| q | For eccentric pin |
| q | Specified torque: 28 Nm |
| 13 - | Door hinge |
| q | Door hinge is one piece. |
| q | Greasing when hinge is replaced → Chapter |
| 14 - | Multi-point socket head bolt |
| q | Specified torque: 50 Nm |
| q | Always renew bolts after loosening. |
| 15 - | Multi-point socket head bolt |
| q | Specified torque: 50 Nm |
| q | Always renew bolts after loosening. |
| 16 - | Multi-point socket head bolt |
| q | Specified torque: 38 Nm |
| q | Always renew bolts after loosening. |
| 17 - | Eccentric pin |
| q | The eccentric pin serves to adjust the shut line. |
| 18 - | Bottom spacer plate |
