Golf Mk6
Adjusting shut lines |
– | Note front door gap dimensions → Rep. gr.00. |
Adjustments are carried out using eccentric pin -8-. |
Other measures such as raising the door have no effect. Subsequent pressure from above will cause the door to sack again. |
– | Loosen bolt -6- for eccentric pin -8-. |
– | Adjust eccentric pin -8- within adjustment range -10- using 15 mm ring spanner -T10344-. |
– | Tighten bolt -6-. Specified torque: 28 Nm |
– | Adjusting striker pin → Chapter |
– | If the setting range is insufficient, proceed as described in the following chapter → Chapter. |
Adjusting for flush fitting |
Use bolts -2, 3, 7, 5 and 9- on door hinge to adjust flush fitting correctly. |
Use door alignment tool -3320- with bit -3320/3-. |
– | Adjusting upper area of door, loosen bolts -7 and 9-. |
– | Specified torque for bolt -9-: 10 Nm |
– | Specified torque for bolt -7-: 38 Nm. |
– | To adjust lower area of door, loosen bolts -2, 3 and 5-. |
– | Specified torque for bolt -2-: 10 Nm |
– | Specified torque for bolts -3 and 5-: 38 Nm. |
– | Adjusting striker pin → Chapter |