Golf Mk6
|
– | Remove the two trim lining mats -1- from the extension -3-. |
– | Remove the three bolts -2- (1.5 Nm). |
– | Release extension from mountings. |
– | Pull extension forwards through opening for handbrake lever. |
– | Release selector insulation -1- from centre console. |
– | Remove the two bolts -2- (1.5 Nm). |
– | Release storage compartments -3- from centre console and disconnect wiring harness (dependent on vehicle equipment). |
Note
An ashtray may be installed instead of a storage compartment -3-, but the removal is identical. |
– | Unclip cover -1- from trim using a small screwdriver. |
– | Unscrew bolt -2- (1.5 Nm). |
– | Pull left footwell trim -3- out of mountings. |
Note
Removal of right footwell trim is identical. |
– | Unclip both side trims -4- from centre console by releasing fasteners with a removal wedge -3409-. |
– | Remove two bolts each -1- and -2- (1.5 Nm). |
– | Remove two bolts each -3- and -4- (1.5 Nm). |
– | Unscrew bolt -5- (1.5 Nm). |
Note
When installing, bolts must be installed in sequence -1-, -2-, -3-, -4- and -5-. |
– | Remove centre console from vehicle. |