volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Installing > < Removing and installing left trim panel on driver side
Removing
Removing
  Note
For greater clarity the steering wheel is not shown in figure, there is no requirement to remove the steering wheel.
–  Switch off ignition.
–  Remove dash panel end trim on driver side → Chapter.
–  Push rotary light switch forwards, turn clockwise until it is vertical and then pull it out and separate wiring harness.
–  Release steering column gap cover from dash panel → Chapter. There is no need to remove the complete steering column trim.
Golf 2009 ►
–  Remove dash panel insert → Electrical system; Rep. gr.90. No need to disconnect wiring harness.
All vehicles
   
–  Pull storage compartment -1- out of mountings.
–  Remove the two bolts -2- (1.5 Nm).
–  Remove the two bolts -3- (1.5 Nm).
–  Unscrew bolt -4- (1.5 Nm).
–  Release trim from dash panel and disconnect wiring harness from headlight range control element.

   

Installing > < Removing and installing left trim panel on driver side