Installing repair kit for seat occupied recognition (vehicles with electrically operated seats) |
Note t
| When installing, ensure that no wiring harness of the seat heating system is located between the seat padding and the mat for seat occupied recognition. |
t
| The pressure hose should be routed without kinks. |
t
| Once vehicle has been reconnected to onboard electrical system, check for clearance of components that have been renewed by moving seat position. |
If the seat occupied recognition system is renewed, a basic setting must be performed on the seat occupied recognition using a vehicle diagnosis tester in „Guided fault finding“ mode. |
WARNING Basic setting must be carried out with seat unoccupied. |
|
Installation is basically carried out in the reverse sequence; note the following when doing this: |
|
|
|