volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Installing > < Removing and installing floor covering

Golf Mk6

Removing
Removing
–  Remove front seats → Chapter.
–  Remove accelerator pedal module → Rep. gr.20.
–  Remove centre console:
t  Basic version → Chapter
t  Highline version → Chapter
–  Remove dash panel end trim → Chapter.
–  Remove bonnet operating lever → Rep. gr.55.
–  Remove sill mouldings:
t  2-door model → Chapter
t  4-door model → Chapter
–  Remove lower A-pillar trims:
t  Driver side → Chapter
t  Front passenger side → Chapter
   
–  Unscrew bolt -1- (1.5 Nm) and pull footrest cover -2- upwards out of mountings in floor panel.
  N70-10295
Right-hand drive vehicles only.
–  Pull clip -1- out and remove stud -2-.
–  Loosen stud -3- from threaded pin.
–  Pull footrest cover -4- up out of mountings in floor panel.
  N70-10296
Only 2-door vehicles and vehicles with electric seat adjustment
–  Remove cover -1- and remove bolt -2- (1 Nm).
–  Remove bracket -3- from seat rail -4-.
  N70-10297
All vehicles
–  Cut floor covering at both -dot-dash lines- in area of handbrake console.
–  Remove floor covering from vehicle.

   

Installing > < Removing and installing floor covering