volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Installing > < Removing and installing C-pillar trim

Golf Mk6

Removing
Removing
–  Switch off ignition.
4-door, vehicles ►06/2005
–  Remove bench seat → Chapter.
–  Remove side padding (4-door):
t  With rear side airbags → Chapter
t  with no rear side airbags → Chapter
–  Remove wheel housing liner (4-door) → Chapter.
4-door, vehicles with rear side airbag 06/2005►
–  Remove side padding (4-door):
t  With rear side airbags → Chapter
–  Remove wheel housing liner (4-door) → Chapter.
4-door, vehicles without rear side airbag 06/2005►
–  Remove wheel housing trim, 4-door, without rear side airbag → Chapter.
2-door
–  Remove upper B-pillar trim. Belt end anchor or anchor rail for front seat belt need not be removed → Chapter.
–  Remove bench seat → Chapter.
–  Remove backrest → Chapter.
–  Remove side panel trim → Chapter.
All vehicles
–  Remove side support for luggage compartment cover → Chapter.
–  Remove roof end strip → Chapter
   
–  Remove airbag emblem -1- and unscrew bolt -2- (4 Nm).
  Note
When reinstalled, airbag emblem -1- must be renewed.
–  Remove nut -3- (1.5 Nm).
–  Release trim from stud of nut -3--arrow A-.
–  Release trim from mountings -arrow B- and from door seal beading.
–  Pull trim upwards out of mountings in body -arrow C-.

   

Installing > < Removing and installing C-pillar trim