volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Installing > < Removing and installing temperature sender before high voltage heater (PTC)G785

Golf Mk6

Removing
Removing
–  Observe general warning instructions for work on high voltage system → Chapter.
–  Removing front noise insulation → General body repairs, exterior; Rep. gr.50.
–  Separate wiring connector -1- from temperature sender before high voltage heater (PTC) -G785--2-.
   
–  Clamp off coolant hoses using hose clamps up to 40 mm -3093-.
  Note
Before removing, release pressure in cooling system if necessary.
  WARNING
Danger of scalding injuries.
When the engine is warm, the coolant temperature may be above 100 °C. The cooling system is pressurised.
If necessary, release pressure and reduce temperature before carrying out repairs.
–  Pull out retaining clip -3-.
–  Remove temperature sender before high voltage heater (PTC) -G785--2-.
  N80-10332

Installing > < Removing and installing temperature sender before high voltage heater (PTC)G785