Note –
| Remove output shaft and pull out small tapered roller bearing outer race → Fig.. |
–
| Insert shims of determined thickness, thickest shim first. |
l
| If the previously used 0.65 mm shim is to be reinstalled, check it for damage. |
If the size of shim required is larger than those listed in the table, insert two shims totalling the correct figure. |
The various thicknesses make it possible to achieve the exact shim thickness required. |
–
| Press in outer race of small tapered roller bearing together with the calculated shim (0.70 mm in example) → Fig. and install output shaft. Tighten bearing support nuts in clutch housing to 25 Nm and then turn 90° further. |
|
|
|