Golf Mk6
Dismantling and assembling selector forks |
Special tools and workshop equipment required |
t | Pressure plate -VW 402- |
t | Thrust piece -3290/1- |
t | Assembly tool -3301- |
t | Thrust piece -VW 431- |
t | Spacer sleeve -VW 472/2- |
t | Drift -10 - 206- |
|
|
|
|
Note
It is not necessary to dismantle the selector fork group → Item in order to dismantle and assemble selector segments, lock washers and angular contact ball bearings. |
1 - | Selector fork group with selector plate |
2 - | Selector segment for 3rd and 4th gear |
q | Identification → Fig. |
q | After installation, selector segment must still rotate freely |
3 - | Angular contact ball bearing |
q | Qty. 4 |
q | Removing → Fig. |
q | Press inner race into outer race → Fig. |
q | Installing → Fig. |
4 - | Lock washer |
q | Always renew |
q | Removing → Fig. |
q | Installing → Fig. |
5 - | 1st/2nd gear selector segment |
q | Identification → Fig. |
q | After lock washer is installed, segment must still rotate freely |
q | Selector fork with selector segment → Fig. |
6 - | 5th gear selector fork with selector segment |
q | Selector segment is permanently connected to selector fork. |
q | Identification → Fig. |
7 - | Pivot pin |
q | For 5th gear selector fork. |
|
|
Note
|
Note
|
|
|