volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Specified torques > < Removing

Golf Mk6

Installing
Installing
Install in the reverse order of removal, observing the following:
  Note
Renew self-locking nuts.
   
–  Insert over-centre spring -2- in mounting bracket from above while holding end of spring with assembly tool -T10178- in installation position.
  A30-0126
–  Receptacle -arrow- for tip -A- of clutch pedal must stand vertically.
–  Insert tip of clutch pedal -1- in bearing recess of over-centre spring.
–  Depress clutch pedal slightly, push bolt through and tighten self-locking nut to specified torque → Chapter.
  N30-0421
Some cars have damping -arrow- on the clutch pedal mounting bracket.
–  Return it to installation position.
  N30-10195
Vehicles without knee airbag
–  Install crash bar -1- and tighten bolt -2- to specified torque → Chapter.
  N30-10117
Continuation for all
–  Mount cable guide -2- on steering column.
–  Install foot well vent -3-. → Rep. gr.80
Vehicles with knee airbag
–  Install knee airbag bracket together with crash bar. → Interior equipment; Rep. gr.69
Continuation for all
–  Install trim and cover below trim on drive side → General body repairs, interior; Rep. gr.68.
  N30-10001

Specified torques > < Removing