Golf Mk6
| Assembly overview - front-wheel drive - removing and installing input shaft, output shafts, differential and selector rods; Golf 2009 ►, Golf Plus, Passat, Passat CC, CC and Eos and Scirocco |
| 1 - | Output shaft for 1st through 4th gears |
| q | Installation position → Chapter |
| q | Dismantling and assembling → Chapter |
| 2 - | Selector rod with selector fork for 1st and 2nd gears |
| q | Installation position → Chapter |
| q | Repairing → Chapter. |
| 3 - | Selector rod with selector fork for 3rd and 4th gears |
| q | Installation position → Chapter |
| q | Repairing → Chapter. |
| 4 - | Output shaft for 5th, 6th and reverse gears |
| q | Installation position → Chapter |
| q | Dismantling and assembling → Chapter |
| 5 - | Selector rod with selector fork for 5th and 6th gears |
| q | Installation position → Chapter |
| q | Repairing → Chapter. |
| 6 - | Selector fork for reverse gear |
| q | Installation position → Chapter |
| q | Distinguishing → Fig. |
| q | Repairing → Chapter. |
| 7 - | Input shaft |
| q | Installation position → Chapter |
| q | Dismantling and assembling → Chapter |
| q | Always renew deep groove ball bearing on input shaft → Item. |
| 8 - | Reverse shaft |
| q | With thrust washer. |
| 9 - | Thrust washer |
| 10 - | Breather |
| q | Connect to slave cylinder |
| 11 - | Clutch housing |
| q | Repairing → Chapter. |
| 12 - | Input shaft seal |
| q | Renewing → Chapter |
| 13 - | O-ring |
| q | Pull onto line connection |
| q | Moisten with brake fluid before installing |
| 14 - | Slave cylinder with clutch release bearing |
| 15 - | Bolt |
| q | Qty. 3 |
| q | Always renew |
| q | Removing and installing → Item |
| 16 - | Countersunk bolt |
| q | Removing and installing → Item |
| 17 - | Flange shaft with compression spring |
| q | Removing and installing → Chapter |
| q | Assembling → Chapter |
| 18 - | Differential |
| q | Dismantling and assembling → Chapter |
