volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Checking selector mechanism > < Overview of selector mechanism in vehicles from 03.2009 onwards

Golf Mk6

Removing and installing selector lever and selector mechanism with selector lever cable from 03.2009 onwards
Removing and installing selector lever and selector mechanism with selector lever cable from 03.2009 onwards
   
Brief description
Selector mechanism and selector lever cable are not allowed to be separated from one another. Both are removed together. In the engine compartment, it may be necessary to provide installation space. Often, it is necessary to remove air filter.
In the interior, it may be necessary to remove centre console.
  Note
Following installation, cable must be checked for ease of movement and be adjusted.
  N34-11454
–  Move selector lever to position „P“ position.
–  Remove selector lever knob → Chapter.
–  Remove centre console → Rep. gr.68.
  N34-11455
–  Remove 4 bolts.
Torque setting 8 Nm.
–  Raise vehicle.
–  Remove heat shield. This makes subsequent removal easier.
  N34-11446
–  Remove securing clip.
–  Securing clips for selector lever cable must always be renewed.
–  Remove cable from ball head.
  N34-11373
–  Before reinstalling cable, set „P“ in vehicle and on gearbox.
–  To remove cable and/or selector mechanism, heat shield must now be removed and, if necessary, parts of exhaust system.
–  → Rep. gr.26
–  Remove heat shield.
  N34-11377
–  Remove selector mechanism.
Install in reverse order of removal.
–  Check cable before ball head is put on → Chapter.
–  Install parts of → exhaust system; Rep. gr.26.
–  Install heat shield → Rep. gr.66.
–  Adjust selector lever cable after installing → Chapter.
  N34-11442

Checking selector mechanism > < Overview of selector mechanism in vehicles from 03.2009 onwards