Volkswagen Workshop Service and Repair Manuals

Assembling output shaft 3 In this procedure, you will see how output shaft is assembled. Make sure that shaft bearing is not damaged during following work on press. If bearing is not going to be renewed then it must be protected.

l  If bearing is pressed on, thrust plate -VW 447 H- must also be used for each pressing operation. l  Pressing off bearing: → Anchor l  Pressing on bearing: → Anchor

–  Fit needle bearing. –  Wet bearing slightly with oil.

–  Put on reverse gear synchromeshed gear, synchro-ring and locking collar. –  Wet friction surface with oil. Synchro-hub can only be put in place. It is pressed on in next step.

–  Press on synchro-hub and locking collar.

–  Fit retaining ring. –  Insert -stop ring-.

–  Put on parking lock gear and bearing. –  Press on both together.