| Adapting installation information |
| The mechatronic unit detects other control units in the vehicle by means of signals on the data bus. Pressing the Adapt installation information button instructs the mechatronic unit to forget all communication partners. |
| All »active partners« are detected once again the next time the ignition system is switched on. |
| You cannot »generate« any faults using this function. Please always perform the Adapt installation information function after the following activities: |
| t
| After a selector lever has been installed. |
| t
| After another control unit has been installed, e.g. engine, ABS or gateway. |
| t
| After work on the steering wheel paddle. |
|
|
|
