Volkswagen Workshop Service and Repair Manuals > Golf Mk6 > Power unit | 4-cylinder diesel engine (1.6 l engine, common rail) | Fuel preparation system Diesel injection | Lambda probe | Assembly overview - Lambda probe | Assembly overview - Lambda probe and exhaust gas temperature sensors (Golf, Touran, Passat 2006?)

Assembly overview - Lambda probe and exhaust gas temperature sensors (Golf, Touran, Passat 2006►)

1 -	Bolt for exhaust gas pressure sensor 1 -G450-

8 Nm

q	Removing and installing → Chapter.

q	Pressure lines to particulate filter 45 Nm

2 -	Measuring lead for pressure differential sender -G505-

3 -	Particulate filter

q	Adaptation must be carried out after renewing particulate filter.

4 -	Exhaust gas temperature sender 3 -G495-

q	Removing and installing → Rep. gr.26.

45 Nm

5 -	Lambda probe -G39- with Lambda probe heater -Z19-

q	New Lambda probes are coated with an assembly paste

q	In the case of a used Lambda probe, grease only the thread with high-temperature paste → Parts catalogue

q	Assembly paste or high-temperature paste must not get into the slots in the Lambda probe

q	Removing and installing → Chapter.

50 Nm

6 -	Exhaust gas temperature sender 4 -G648-

q	Removing and installing → Rep. gr.26.

45 Nm

7 -

Nut

Exhaust gas temperature sender 1 -G235--1-

Removing and installing exhaust gas temperature sender 1 -G235- → Rep. gr.26.

Connectors on plenum chamber bulkhead

1 -	Electrical connector for charge pressure control solenoid valve -N75-

2 -	Electrical connector for exhaust temperature sender 4 -G648-

3 -	Electrical connector for exhaust temperature sender 1 -G235-

4 -	Electrical connector for Lambda probe -G39-

5 -	Electrical connector for exhaust temperature sender 3 -G495-

Volkswagen Workshop Service and Repair Manuals