volkswagen Workshop Repair Guides

VW Golf MK6 Workshop Service and Repair Manuals

ABOUT US
Radiator/radiator fan > < Removing and installing left coolant pipe

Removing and installing right coolant pipe for Golf Mk6 diesel engine

Removing and installing right coolant pipe
Removing and installing right coolant pipe
Special tools and workshop equipment required
   
t  Hose clamps up to  25 mm -3094-
  W00-0079
t  Drip tray for workshop hoist -VAS 6208-
  W00-10228
t  Hose clip pliers -VAS 6362-
Removing
–  Remove engine cover panel → Chapter.
  W00-10427
–  Loosen bolt -1- and remove bolt -2- and nut -3-.
–  Remove bracket -4- from fuel filter, and lay fuel filter -7- aside with fuel hoses -5- and -6- connected.
–  Remove noise insulation → General body repairs, exterior; Rep. gr.66.
–  Remove front right wheel housing liner: → General body repairs, exterior; Rep. gr.66.
  A20-10395
–  Place drip tray for workshop crane -VAS 6208- beneath engine.
–  Pull connector -3- off radiator outlet coolant temperature sender -G83-.
–  Clamp off coolant hoses with hose clips -3094-.
  A19-10640
–  Loosen hose clamps -arrows- and pull coolant hoses off right coolant pipe.
–  Unscrew nut -1- and bolt -2- and remove right coolant pipe.
Installing
l  Specified torques → Chapter.
Installation is carried out in the reverse order; note the following:
  Note
Secure hose connections with hose clips corresponding to the series equipment → Electronic parts catalogue.
–  Replenish coolant → Chapter.
  A19-10640

Radiator/radiator fan > < Removing and installing left coolant pipe