volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing toothed belt, tensioning roller A > < Assembly overview - toothed belt

Golf Mk6

Removing and installing toothed belt
Removing and installing toothed belt
→ Chapter „Removing and installing toothed belt, tensioning roller A“
→ Chapter „Removing and installing toothed belt, tensioning roller B“
   
Special tools and workshop equipment required
t  Locking pin -3359-
t  Crankshaft stop -T10050-
t  Counterhold tool -T10172-
t  Angle driver -T10264- for tensioning roller
t  Locking tool -T10265-

   
t  Angle driver, 8 mm -T10409- for tensioning roller B
Not illustrated:
t  Torque wrench -V.A.G 1331-
t  Torque wrench -V.A.G 1332-
Differences between versions of tensioning roller
  Note
2 versions of tensioning roller are fitted. They are not interchangeable. When performing adjusting measures, check first to see which tensioning roller is installed.
Observe different directions of rotation during tensioning
  W00-10773
Features tensioning roller A:
t  Locking tool -T10265- required for installation.
t  Check tensioning roller is seated correctly in timing belt guard → Fig.
t  Tension toothed belt by turning tensioning roller eccentric »clockwise«
Features tensioning roller B:
t  Locking tool not required.
t  Tensioning roller is not seated in timing belt.
t  Tension toothed belt by turning tensioning roller eccentric »counter clockwise«
  N15-10715

Removing and installing toothed belt, tensioning roller A > < Assembly overview - toothed belt