Golf Mk6
Part III |
1 - | Knock sensor 1 -G61- |
q | Contacts gold plated. |
2 - | 20 Nm |
q | The torque setting influences the function of the knock sensor. |
3 - | Oil dipstick |
q | The oil level must not be above the max. mark! |
q | Markings → Fig.. |
4 - | Bracket |
q | For ignition transformer. |
5 - | 10 Nm |
6 - | 10 Nm |
7 - | 10 Nm |
8 - | Bracket |
9 - | 6 Nm |
10 - | Oil filter bracket with attachments |
q | Engine code BGU → Chapter. |
q | Engine codes BSE, BSF, CCSA, CMXA → Chapter |
11 - | 15 Nm + turn 90° further |
12 - | Gasket |
q | Renew. |
13 - | 10 Nm |
14 - | Engine speed sender -G28- |
15 - | Connection |
16 - | 15 Nm |
17 - | O-ring |
q | Renew. |
18 - | Seal |
q | Renew. |
19 - | Thermostat |
q | Removing and installing → Chapter. |
q | Checking: Heat thermostat in water. |
q | Opening begins at approx. 85 °C. |
q | Fully open at approx. 105°C. |
q | Opening lift min. 7 mm. |
20 - | Cylinder block |
q | Removing and installing sealing flange and flywheel → Chapter. |
q | Removing and installing crankshaft → Chapter. |
q | Dismantling and assembling pistons and conrods → Chapter. |
21 - | Coolant pipe seal |
q | Renew. |