Caution The studs (M6x80) must be screwed into cylinder head before installing camshaft housing. |
The camshaft housing is guided by the studs, so that the roller rocker fingers do not slip off the supporting elements. |
|
l
| The pistons must not be positioned at TDC. |
–
| Remove sealant residues from cylinder head and camshaft housing with a rotating brush, e.g. a hand drill with a plastic brush (wear eye protection). |
–
| Clean sealing surfaces carefully. They must be free of oil and grease. |
–
| Also prevent dirt and residual sealant from entering cylinder head. |
Caution Before using camshaft clamp -T10171 A- you must check that the pins on the tool project by at least 7 mm. |
If this is not the case, the camshaft clamp is defective and must be renewed. |
The camshaft clamp must not be positioned using any kind of hammer. |
|
|
|
|