Golf Mk6
Note
|
1 - | 150 Nm + 1/2 turn (180°) further |
q | Renew. |
q | Removing and installing crankshaft pulley → Chapter. |
q | Contact surface for securing bolt must be free of oil and grease. |
q | Oil threads before inserting. |
q | Secure pulley against turning with counterhold 3415. |
q | The turning further angle can be measured with a commercial protractor. |
2 - | Belt pulley |
q | Contact surfaces must be free of oil and grease. |
q | Secure against turning with counterhold -3415- when removing and installing |
q | Removing and installing poly V-belt → Chapter. |
3 - | Seal |
q | Renew. |
4 - | Bearing bush |
q | Contact surfaces must be free of oil and grease. |
5 - | O-ring |
q | Renew. |
6 - | Cylinder block |
q | Removing and installing → Chapter |
7 - | 60 Nm + 1/4 turn (90°) further |
q | Renew. |
8 - | Flywheel/drive plate |
q | When removing and installing flywheel, lock with counterhold -T10044-. |
9 - | Intermediate plate |
q | Must seat on dowel sleeves. |
q | Do not damage or bend when assembling. |
10 - | 10 Nm |
q | Renew. |
11 - | Sealing flange with sender wheel and oil seal |
q | Removing and installing engine speed sender -G28- (not shown) → Chapter. |
q | Specified torque for engine speed sender -G28-: 5 Nm. |
q | Renew sealing flange complete with oil seal and sender wheel only. |
q | Renewing crankshaft sealing flange - flywheel end → Chapter. |