volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Installing > < Removing and installing oil sump

Golf Mk6

Removing
Removing
–  Remove engine splash protection.
–  Disconnect front exhaust pipe from exhaust manifold → Chapter.
–  Pull connector off oil level and oil temperature sender -G266-.
–  Drain engine oil.
Engine codes BUD and CGGA
   
–  Unscrew bolts -arrows- and remove cover plate from gearbox housing.
Continuation for all vehicles
–  Unbolt sump sealed with liquid gasket.
–  Remove sump, it may be necessary to release sump by tapping lightly with a rubber head hammer.
–  Remove sealant residue from cylinder block with a flat scraper.
  N17-10136
–  Remove sealant residue on sump with a rotating brush, e.g. an electric drill with plastic brush attachment (wear eye protection).
–  Clean sealing surfaces. They must be free of oil and grease.
  N17-0012

Installing > < Removing and installing oil sump