Golf Mk6
|
| 1 - | 23 Nm |
| q | Insert with locking fluid. |
| 2 - | Camshaft toothed belt pulley |
| 3 - | 100 Nm |
| q | Use counterhold tool -3415- to loosen and tighten. |
| 4 - | 10 Nm |
| q | Insert with locking fluid. |
| 5 - | Rear toothed belt guard |
| 6 - | Woodruff key |
| 7 - | Seal |
| q | Renew. |
| 8 - | 10 Nm |
| 9 - | Breather connection |
| 10 - | Special bolt, 9 Nm |
| q | Renew if damaged or leaking. |
| 11 - | Seal |
| q | Renew if damaged or leaking. |
| 12 - | Cap |
| 13 - | Cylinder head cover |
| q | To remove, loosen bolts from outside inwards. |
| q | To install, tighten bolts from inside outwards. |
| 14 - | Cylinder head cover gasket |
| q | Renew if damaged or leaking. |
| q | Press into spacer sleeves of → Item. |
| 15 - | Cylinder head bolt |
| q | Renew. |
| q | Observe sequence when loosening and tightening → Chapter. |
| 16 - | 10 Nm |
| 17 - | Hall sender -G40- |
| q | To remove or install, remove throttle valve module -J338- |
| 18 - | O-ring |
| q | Renew. |
| 19 - | Cylinder head |
| q | Removing → Chapter |
| q | Check for distortion → Chapter. |
| q | Reworking limit → Fig.. |
| q | Installing → Chapter. |
| q | If renewed, renew coolant. |
| 20 - | Connection |
| 21 - | 10 Nm |
| 22 - | O-ring |
| q | Renew. |
| 23 - | Cylinder head gasket |
| q | Installation position: part number faces cylinder head and must be readable from the inlet side. |
| q | If renewed, renew coolant. |
