Golf Mk6
| Assembly overview - exhaust system (engine code CAWB) |
| 1 - | 40 Nm |
| q | Renew |
| q | Coat studs of exhaust manifold with high-temperature paste. |
| q | High-temperature paste -G 052 112 A3- |
| 2 - | Lambda probe -G39- |
| q | Bank 1, probe 1 |
| q | 55 Nm |
| q | The thread on new Lambda probes is coated with high-temperature paste. |
| q | When re-using the old Lambda probe, coat only the thread with high-temperature paste; the paste must not get into the slots of the probe body. |
| q | High-temperature paste -G 052 112 A3- |
| 3 - | Front exhaust pipe with catalytic converters |
Caution
|
| q | Protect catalytic converter from damage by knocks and impact |
| q | Removing and installing → Chapter |
| q | Aligning exhaust system free of stress → Chapter. |
| 4 - | Rubber mounting |
| q | Renew if damaged. |
| 5 - | Threaded union |
| q | Tighten bolted connections evenly. Specified torque and installation position → Fig. |
| 6 - | Rear silencer |
| q | In initial equipment, component with centre silencer. Can be renewed individually for repair purposes. |
| q | Separate exhaust system → Chapter. |
| 7 - | Mounting |
| q | Renew if damaged. |
| 8 - | 25 Nm |
| 9 - | Rear clamp |
| q | For separate replacement of centre and rear silencers |
| q | Tighten bolted connections evenly. Specified torque and installation position → Fig. |
| 10 - | Centre silencer |
| q | Combined in one unit with rear silencer as original equipment. Can be renewed individually for repair purposes. |
| q | Separate exhaust system → Chapter. |
| 11 - | 25 Nm |
| 12 - | Front clamp |
| q | Tighten bolted connections evenly. Specified torque and installation position → Fig. |
| q | Tighten bolted connections evenly. |
| 13 - | Threaded union |
| q | Tighten bolted connections evenly. Specified torque and installation position → Fig. |
| 14 - | Mounting |
| q | For centre silencer. |
| 15 - | Mounting |
| q | Renew if damaged. |
| 16 - | Seal |
| q | Renew |
