Volkswagen Workshop Service and Repair Manuals

Removing and installing accelerator module Special tools and workshop equipment required

t  Release tool -T10238- For right-hand drive:

t  Release tool -T10240- »Carry out the following work sequence« Removing

–  Remove steering column cover -arrows-. –  Prise out cap -3- using a screwdriver. –  Remove securing bolt -2-.

–  Release connector -1- and pull it off accelerator module.

–  Push release tool -T10238- (for right-hand drive vehicles release tool -T10240-) into intended holes as shown to stop and remove accelerator module. Installing

–  Reconnect connector -1- to accelerator module -4-. Lock connector -arrow-. –  Press accelerator module onto securing pins -5-. –  Insert centring pin -6- into hole in underbody. –  Secure accelerator module with bolt -2- and install cap -3-.

–  Install steering column trim.