Golf Mk6
Schematic diagram of activated charcoal filter system (engine codes CBTA, CBUA) |
1 - | Fuel system diagnostic pump -V144- |
q | Fitting location: In rear right wheel housing beneath liner |
q | Check → Vehicle diagnostic tester. |
q | Removing and installing → Chapter. |
2 - | Connecting line |
q | From fuel system diagnosis pump -V144- to activated charcoal filter |
q | Clip onto bracket. |
3 - | Activated charcoal filter |
q | Location: down in spare wheel well |
q | A filter is also installed with engine code CBUA → Item |
q | Removing and installing → Chapter. |
4 - | Separating point |
q | Rear right on fuel tank |
5 - | Throttle valve module -J338- |
q | Removing and installing → Fuel preparation, injection; Rep. gr.24 |
6 - | Activated charcoal filter solenoid valve 1 -N80- |
q | Check → Vehicle diagnostic tester. |
7 - | Vacuum line |
q | Connected to intake manifold |
8 - | Separating point |
q | Front right in engine compartment under coolant expansion tank |
9 - | Breather line |
q | White |
q | From activated charcoal filter to activated charcoal filter solenoid valve 1 -N80- |
q | Installation position: On right under vehicle |
q | Secured to fuel tank. |
10 - | Vacuum line |
q | Green |
q | From engine to fuel system diagnosis pump -V144- |
q | Installation position: On right under vehicle |
q | Secured to fuel tank. |
11 - | Separating point |
q | Front right on fuel tank in vicinity of fuel filter |
12 - | Filler neck |
13 - | Breather line |
q | From filler neck to activated charcoal filter |
14 - | Air filter |
q | For fuel system diagnostic pump -V144- |