Golf Mk6
Assembly overview: suspension strut for adaptive chassis control DCC |
1 - | Shock absorber with front left shock absorber damper adjustment valve -N336- |
q | Can be renewed separately |
q | Allocation → Electronic parts catalogue „ETKA“ |
2 - | Bump stop |
q | Allocation → Electronic parts catalogue „ETKA“ |
3 - | Protective sleeve |
4 - | Coil spring |
q | Removing and installing → . |
q | Observe colour coding |
q | Allocation → Electronic parts catalogue „ETKA“ |
Spring allocation via PR No. |
These numbers are located on the vehicle data sticker. |
q | Surface of coil must not be damaged. |
5 - | Deep groove ball thrust bearing |
6 - | Suspension strut mounting |
q | Note correct installation position → Anchor |
7 - | Hexagon nut |
q | 60 Nm |
q | Self-locking |
q | Always renew after removing. |
8 - | Suspension strut turret |
9 - | Bracket |
q | For front left body acceleration sender -G341- |
q | Removing and installing → Chapter. |
q | An „L“ is punched into bracket |
Note
Make sure to use correct bracket. |
10 - | Front left body acceleration sender -G341- |
q | Removing and installing → Chapter. |
q | Note installation position on bracket → Item → Fig. |
11 - | Bolt |
q | 5 Nm |
q | Always renew after removing. |
12 - | Bolt |
q | 15 Nm + 90° further |
q | Always renew after removing. |
13 - | Bracket |
q | For front right body acceleration sender -G342- |
q | Removing and installing → Chapter. |
q | An „R“ is punched into bracket |
14 - | Front right body acceleration sender -G342- |
q | Removing and installing → Chapter. |
q | Note installation position on bracket → Item → Fig. |
15 - | Nut |
q | 5 Nm |
q | Always renew after removing. |
Note
|