Volkswagen Workshop Service and Repair Manuals > Golf Mk6 > Running gear, axles, steering | Self-levelling air spring system | Components of adaptive chassis control DCC and fitting locations | Removing and installing front left/right vehicle level senderG78/G289

Removing and installing front left/right vehicle level senderG78/G289

Removing and installing front left/right vehicle level sender -G78/G289-

Special tools and workshop equipment required

t	Torque wrench -V.A.G 1331-

Removing

Note

t	To remove front left vehicle level sender -G78-, steering must be turned to right lock to ensure clearance between suspension link and anti-roll bar.

t	To remove front right vehicle level sender -G289-, steering must be turned to left lock to ensure clearance between suspension link and anti-roll bar.

–	Separate connector.

–	Remove bolt and nut.

–	Take out vehicle level sender.

Installing

Install in reverse order. Note the following points:

Note

t	Lever on vehicle level sender must face towards outside of vehicle.

t	Thread of vehicle level sender must be screwed into front hole in suspension link. Lug of bracket for vehicle level sender must engage in rear hole in order to guarantee correct installation position.

–	Perform basic setting of adaptive chassis control DCC → Chapter

–	Perform basic setting of headlights → "Guided fault-finding" function of vehicle diagnostic, testing and information system VAS 5051

Specified torques

Component

Specified torque

Bolt to subframe

9 Nm

Nut

t	Use new nut

9 Nm

Volkswagen Workshop Service and Repair Manuals