Volkswagen Workshop Service and Repair Manuals > Golf Mk6 > Vehicle electrics | Communication | Infotainment | Aerial systems | Removing and installing amplitude modulation (AM) frequency filter

Removing:

Before beginning dismantling work, perform the following steps:

–	Switch off ignition and all electrical consumers and remove ignition key.

Rear lid trim trim must be removed before the amplitude modulation (AM) frequency filter for can be renewed.

–	Remove red securing clip -1- from connector housing in direction of -arrow-. Press then fastener -2- and disconnect connector.

–	Procedure for two other connectors is identical.

–	Unscrew the 3 securing bolts -arrows- and remove the frequency filter.

Volkswagen Workshop Service and Repair Manuals