Volkswagen Workshop Service and Repair Manuals > Golf Mk6 > Vehicle electrics | Electrical system | Lights, lamps, switches inside, anti-theft system | Anti-theft alarm (ATA) | Alarm hornH12

Removing and installing alarm hornH12

Removing and installing alarm horn -H12-

Special tools and workshop equipment required

t	Drill -VAS 5134-

Note

The anti-theft alarm must be deactivated → Chapter before removing the alarm horn.

Removing:

–	Switch off ignition and all electrical consumers and remove ignition key.

–	Remove front right wheel housing liner → General body repairs, interior; Rep. gr.66.

–	Use drill -VAS 5134- and a drill bit to drill out the heads of both pop rivets -arrows-.

–	Release connector -1- by opening the cover -2- using a small screwdriver and remove the alarm horn -H12--3- from the wheel housing.

–	Remove pop rivet residues -arrow- from body holes.

Installing:

Note

Remove from vehicle all metal swarf and pop rivet residues produced by drilling.

–	Perform necessary corrosion protection measures → Rep. gr.Allgemeine Hinweise.

–	Connect connector to alarm horn -H12-.

Note

For reasons of clarity, the alarm horn -H12- is not shown in the following illustration, therefore the connector is shown disconnected.

–	Guide clip -2- of alarm horn -H12- into aperture in body -1-.

–	Secure alarm horn -H12- using new pop rivets.

–	Install front right wheel housing liner → General body repairs, interior; Rep. gr.66.

Volkswagen Workshop Service and Repair Manuals