volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Vehicle inclination senderG384 > < Anti-theft alarm system sensorG578

Golf Mk6

Removing and installing anti-theft alarm sensorG578
Removing and installing anti-theft alarm sensor -G578-
Special tools and workshop equipment required
   
t  Removal wedge -3409-
  Note
t  When removing and installing components that are in view (switches, covers, trim and so on), mask off areas in which tools (removal wedge -3409-, screwdriver) are used to lever out those components using commercially available tape.
t  The following illustrations show removal and installation of the anti-theft alarm sensor -G578- on a vehicle with sliding/tilting sunroof. Removal and installation of anti-theft alarm sensor -G578- on vehicles without sliding/tilting sunroof are carried out in the same way.
Removing:
–  Switch off ignition and all electrical consumers and remove ignition key.
–  Remove front interior light:
t  Vehicles with anti-theft alarm (ATA) → Chapter
t  Vehicles without anti-theft alarm (ATA) → Chapter
  W00-0016
–  Release the three locking lugs -arrows- and remove anti-theft alarm sensor -G578--1- from interior light, taking connected wiring length into consideration.
  N96-10748
–  Unclip wires from brackets -1-.
–  Release fasteners -arrows- and pull both interior monitor sensors -2- out of interior light.
–  Take anti-theft alarm sensor -G578- out of vehicle.
Installing:
Installation is carried out in reverse order of removal.
  N96-10749

Vehicle inclination senderG384 > < Anti-theft alarm system sensorG578