Volkswagen Workshop Service and Repair Manuals > Golf Mk6 > Vehicle electrics | Electrical system | Lights, lamps, switches outside | Entry and start authorisation (KESSY) | Entry and start authorisation control unitJ518 | Removing and installing (left-hand drive models) entry and start authorisation control unitJ518

Removing and installing (left-hand drive models) entry and start authorisation control unitJ518

Removing and installing (left-hand drive models) entry and start authorisation control unit -J518-

After renewing the electronic steering column lock control unit -J518-, the „entry and start authorisation“ system must be coded → Chapter.

Removing:

–	Remove driver side footwell vent → Heating, ventilation, air conditioning system; Rep. gr.80.

–	Release fastener -arrow- and pull entry and start authorisation control unit -J518--2- together with bracket -3- backwards, out of pedal bracket of brake pedal, taking connected wiring length into consideration.

–	Release and disconnect connector -1- and remove entry and start authorisation control unit -J518--2- from bracket -3-.

Installing:

Install in the reverse order of removal. When doing this, note the following:

–	Insert entry and start authorisation control unit -J518--2- into bracket -3-.

–	Insert bracket together with control unit into guides on pedal bracket of brake pedal until it securely engages.

–	Insert connector -1- and lock it.

After renewing the electronic steering column lock control unit -J518-, the „entry and start authorisation“ system must be coded → Chapter.

Volkswagen Workshop Service and Repair Manuals